Toyota Truck/80 Series ABS Sensor Delete Plugs- Full Kit

Product Description

This is been on my “to do” list for a pretty long time. For those of you with a Toyota truck or just Toyota axles, with ABS, but you are part time or you just want to delete the ABS pump and harness, this is for you. Deleting your ABS pump is one thing and it’s not terribly difficult. But you can’t delete the sensors and harness because then you have gaping holes in your knuckles. These bad boys will not only plug the hole in all four corners of the truck, but it will allow you to grease the front knuckles through the OEM zerc supplied (BE SURE TO REMOVE SQUARE FILL PLUG FIRST!!!!), AND you now get to remove and sell your used harness to some poor guy trying to fix his non working/damaged sensor.

BTW that ABS sensor harness is all one piece and dealer is over $1000

Now I did notice there is a zerc fitting that replaces the square fill plug on our knuckles. The reasons I think that is beyond STUPID is because that square plug IS your fill AND inspection plug. If you are filling it how do you know it’s too much? And if you are filling it there is no where to vent except out the seals. Just dumb. With these new plugs you can fill through the zerc AND still have the square plug open to make sure you aren’t over filling. Fronts get an o-ring and zirc. Rears do not need o-ring nor zerc. Rears fit 80 Series axles only.

Includes:
• (2) Front machined and anodized aluminum ABS plug w/OEM zerc and cover
• (2) Rear machined and anodized aluminum ABS plug (fits 80/100 Series only)
• (1) Pouch of Syl-Glyde brake grease

Also works for:
• 2000-2006 Tundra front and rear (both ar same so two front kits needed)

UPDATE: Heard back from a customer to verify that these indeed fit Lexus vehicles and especially the IS300.

MADE in USA