Bulkhead fittings are soooooo boring, ugh :(
It was time to change up the bulkhead use for On-Board-Air (OBA). your typical bulkhead is simple, utilitarian, and as unsexy as they come. Typical air fitting bulkheads are NPT threaded on both sides which require a hole to drop into. From there a washer and nut cinch everything up. Sure, it works fine and does its job. But as we spend more time customizing our vehicles, it seemed the perfect time to redevelop the bulkhead fitting.
This is the new Wits' End 3-Earned Machined Aluminum Bulkhead Fitting. Its CNC machined to give it a custom look and feel. Although it still uses the same main hole to drop the fitting down to sit flush, this has the addition of three ears that are used to secure the fitting in place. No more trying to dial in where the hex of the bulkhead is going to end up.
The bulkhead fitting is tapped for 1/4" NPT on both sides so you can add your 1/4" NPT coupler or nipple of your choice up top and your push-to-connect fitting of your choosing form the bottom. There are three anodized colors to choose from: BLUE, BLACK and RED.
• (1) CNC machined aluminum bulkhead fitting
• (3) Stainless sets: button head, washer, nut
• (1) Template for marking
• Application: air
• Connection: female NPT to female NPT
• Material: 6061 aluminum
• Thread size: 1/4" NPT both sides
MADE in USA
Videos Hide Videos Show Videos
1 Review Hide Reviews Show Reviews
I purchased for a very tight installation space for my air compressor and air ride system.