null

Solar/Electrical

Listed here are a few products that are either sourced and/or manufactured and assembled in-house. Every now and then there is a problem that creeps up that needs an elegant solution, or sometime its all about convenience. Its all about having everything in one place to find or having everything being thought of for you. A lot of people have a difficult time trying to wrap their heads around basic 12v vehicle wiring. The aim to reduce both the fear and the anxiety.

  • 80 Series Antenna Mast and Bezel Kit (AMB-1KIT)

    80 Series Antenna Mast and Bezel Kit, 96-97

    This is the kit for the 96-97 LX450 and the 97 40th Anniversary Land Cruisers. Earlier 80 Series antennas uses a mast that is no longer available from Toyota but can be found in the aftermarket world. If an OEM replacement is found I will update here...

    $104.80
    Add to Cart
  • OEM Wire Harness Tape (WHT-1)

    OEM Wire Harness Tape

    This is the OEM wire harness tape used on the Toyota Land Cruiser. This is the ideal wrap tape for under the hood. For harness tape that runs along the inside of body panels its preferred to use TESSA tape for it helps reduce noise during vibration...

    $35.40
    Add to Cart
  • 60 Series Fusible Link (FLK-3)

    60 Series Fusible Link

    Fusible link used on the 60 Series Land Cruiser with the 2F or 3B. This fusible link is NOT APPLICABLE for any other Land Cruiser. Part no: 90982-08135 Fits:• BJ60 3B (08/80-10/82)• FJ60 2F (08/80-8/87) MADE in JAPAN

    $61.00
    View Details
  • 80 Series Center Diff Lock Switch, 93-97 only (CDL-1)

    80 Series Center Diff Lock Switch, 93-97 only

    US bound 80 Series Land Cruisers never came with the Center Diff Lock Switch even though the harness and plug is in the dash rear to plug one in. Adding this button gives you the ability to manually control the center diff. But doing the additional pin-7...

    $130.75
    Add to Cart
  • 60 Series Manual Antenna Assembly (MAA-2)

    60 Series Manual Antenna Assembly

    OEM replacement manual antenna assembly for the FJ60 Land Cruiser (81-87). When installing keep in mind that the antenna sweeps back, not straight up. That will make all the difference in trying to install it correctly.  Part no: 86300-90A12...

    $70.40
    Add to Cart
  • 80/100 Series Transfer Indicator Switch (TIS-1)

    80/100 Series Transfer Indicator Switch

    On the 80 Series Land Cruiser this is used For the Transfer Indicator Switch No. 1 and No. 3. This should be the first check when you can't get the lockers to light up on the dash. These commonly go bad but they can be sprayed with brake clean and...

    $97.85
    Add to Cart
  • Emergency Shut-off Key- Aluminum (ESK-1)

    Emergency Shut-off Key- Aluminum

    Recently a double active kill switch was added into a customer’s 80 Series Land Cruiser. One of the things I knew I HATED was seeing a big bright red key screaming “here I am”. As an emergency power shut off it’s exactly what you...

    $35.00
    Add to Cart
  • Horn Contact Pin "Plate" (PIN-1)

    Horn Contact Pin "Plate"

    This OEM horn pin fits just about every Toyota on the road from 1974 til about 1990ish. The applications are too many to list. But if your horn uses this style of pin this is likely the one. The issue with the horn not working is very typically that this...

    $7.60
    Add to Cart
  • 60 Series Dome Light Lens (DLL-2)

    60 Series Dome Light Lens

    Dome light lens found on 80s and 90s Toyota Trucks and cars. Original is very likely either crumbling or very yellow or melted. Part no: 81241-20060 Fits:• Toyota 4Runner 1984-1995 • Toyota Land Cruiser 1981-1990 • Toyota Pickup 1984-1995...

    $8.35
    Add to Cart
  • 80 Series Battery Cable Clamp- 1/0AWG (BCC-1)

    80 Series Battery Cable Clamp- 1/0AWG

    After redoing all of your battery cables, and cleaning up the loom, your 80 may benefit from re-routing the cables. Making the starter cable a little longer, to keep it looser, is a good idea for positioning given the plethora of battery options out...

    $44.00
    Add to Cart
  • OEM Factory Locker Dial Kit for ARB Lockers (FLD-1KIT)

    OEM Factory Locker Dial Kit for ARB Lockers

    NOTE: Due to components getting harder to get please understand it could take many weeks before these can go out. Please be patient. If needed urgently its suggested you figure out your own solution using the schematic posted here. NOTE x2: this is...

    $85.00 - $140.00
    Choose Options
  • 80 Series Harness Clip-Core Support (CLIP-1)

    80 Series Harness Clip-Core Support

    Ever notice those three plastic nubs on the radiator core support that are just in front of the radiator? You know those plastic protrusions you have held on with carefully placed zip-ties...or are just missing altogether? Well these are the harness...

    $6.20
    Add to Cart
  • Modified ARB 12V fused cig plug end w/ open wire (FPE-1)

    Modified ARB 12V fused cig plug end w/ open wire

    For those looking to utilize ARB's 12v cigarette plug end into a new DC accessory. This plug/wire section is what is left after the proprietary fridge end for the ARB fridges are cut off for the custom coiled cables for the fridges. Rather than throw...

    $5.00
    Add to Cart
  • 80 Series 1FZ Complete Engine Wire Harness (EWH-1)

    80 Series 1FZ Complete Engine Wire Harness

    On the 80 Series 1FZ engines it is not too uncommon to find a need to replace the entire engine harness. Perhaps you are rebuilding the entire motor and you want all fresh wiring and non-brittle connectors. Perhaps the 24 year old plastic clip at the...

    $676.00
    Add to Cart
  • OEM Toyota Grease Kit- Plastic Geared Electric Motors (TGK-1)

    OEM Toyota Grease Kit- Geared Electric Motors

    Although spec'd for Lexus steering shaft lubrication its formulation is near identical to the grease used internally on the plastic gears found on the electric seats in Land Cruisers (and likely other Toyota vehicles). When completely rebuilding the seat...

    $17.50
    Add to Cart
  • Body Grease- Molykote 102 (BGM-102)

    Body Grease- Molykote 102

    This is the Toyota specific grease used in electrical motors on the Land Cruisers. Typical applications would be the windshield motors and the diff e-lock motors that commonly need to be rebuilt. One bottle is easily enough for two motor's worth of...

    $58.75
    Add to Cart
  • Late 80 Series Toyota Emergency Dash Switch (EDS-1)

    Late 80 Series Toyota Emergency Dash Switch

    Although this is the same switch used in your late 80 Series Land Cruiser as a typical hazard switch, this switch has been commonly used as the go-to switch for repurposing for alternative uses. Its a simple on-off switch and is typically used for...

    $71.50
    Add to Cart
  • Late 80 Series Toyota Aux Light Switch (ALS-1)

    Late 80 Series Toyota Aux Light Switch

    Toyota Fog Light Switch that can be easily repurposed as an auxiliary light switch. Can be used without modification in any late model 80 Series Land Cruiser. Part no: 00550-35976 Options:• Carling Switch Blanks• Carling Switchplate• JDM...

    $11.15
    Add to Cart
  • Carling Switch Blank (CSB-1)

    Carling Switch Blank

    The Carling snap-in switch blanks are used to fill in the blanks when a switch isn't needed on the Useless Astray Switchplate- Carling Switches. The blanks are black and simply pop into place. Options:• Carling Switch Blanks• Carling...

    $2.00
    Add to Cart
  • Anderson SB175 Environmental Boot- Load Side (AEB-175L) 
*Note that SOURCE is indicated for photo only

    Anderson SB175 Environmental Boot- Load Side

    These Anderson Environmental Boots are keyed as either SOURCE or LOAD sides. Use SOURCE on the cable side that is directly connected to your battery or power source. Use LOAD one the cable side of the device/accessory that you are looking to plug in to...

    $17.00
    View Details
  • Anderson SB50 Environmental Boot- Load Side (AEB-50L)

    Anderson SB50 Environmental Boot- Load Side

    These Anderson Environmental Boots are keyed as either SOURCE or LOAD sides. Use SOURCE on the cable side that is directly connected to your battery or power source. Use LOAD one the cable side of the device/accessory that you are looking to plug in to...

    $7.00
    Add to Cart
  • Fuel Injector Connector Housing (FIC-1)

    Fuel Injector Connector Housing

    Original Toyota Sumitomo 2 Way TS Plug Housing for Denso Injectors. Connector ONLY. Terminals not included. These connectors are ALWAYS brittle and tend to break after 20+ years on our trucks. They seem to want to break at the most inopportune time. You...

    $9.30
    Add to Cart
  • Anderson SB50 Environmental Boot- Source Side (AEB-50S)

    Anderson SB50 Environmental Boot- Source Side

    These Anderson Environmental Boots are keyed as either SOURCE or LOAD sides. Use SOURCE on the cable side that is directly connected to your battery or power source. Use LOAD one the cable side of the device/accessory that you are looking to plug in to...

    $5.00
    Add to Cart
  • Anderson SB50 Flush Mounting Bracket (AMK-4)

    Anderson SB50 Flush Mounting Bracket

    The Flush Mounting Bracket is ideal for the perfectionist. This bracket was developed to have a clean install for the source side of the Anderson SB50 connector. A notch is needed to be cut into the mounting material to get the bracket front face mounted...

    $20.00
    Add to Cart
  • Connector Pin Tool-basic (PST-2)

    Connector Pin Tool-basic

    If you own any Toyota long enough you will eventually need to either modify or repair an electrical connector. This can be daunting because it seems everyone is already having a hard enough time building up the courage to even commit to "cutting the...

    $43.00
    Pre-Order Now
  • Prison Shank- Connector Pin Tool (PST-1)

    Prison Shank- Connector Pin Tool

    If you own any Toyota long enough you will eventually need to either modify or repair an electrical connector. This can be daunting because it seems everyone is already having a hard enough time building up the courage to even commit to "cutting the...

    $52.00
    Pre-Order Now
  • Waterproof Accessory Switch- 20A (WAS-20)

    Waterproof Accessory Switch- 20A

    This is the 20A, waterproof, small-footprint accessory switch that was chosen as the default switch used on all Wits' End products that facilitate a high-amperage switch. Its small size and waterproof design allows for usage in areas that get dusty or...

    $6.50
    Add to Cart
  • Fusible Link for 80 Series Land Cruiser (FLK-1)

    Fusible Link for 80 Series Land Cruiser

    Replacement fusible link for all US 3FE and 1FZ 80 Series Land Cruisers. Recommended to get two, one to replace what you have and one for a spare. This is an OEM original part. Part no. 90982-08264 Made in Japan

    $18.00
    Add to Cart
  • Anderson SB50 Connector Kit (AMK-3)

    Anderson SB50 Connector Kit

    Anderson Powerpole SB50 connectors are a convenient and secure quick disconnect for 12v systems up to 120 amps. A connector "kit" includes all the parts needed for a single connection. Contains:• (2) Anderson SB50 gray connectors• (4) Metal...

    $7.50
    Add to Cart
  • Anderson SB50 Flush Mounting Bracket Kit (AMK-1)

    Anderson SB50 Flush Mounting Bracket Kit

    The Flush Mounting Bracket is ideal for the perfectionist. This bracket was developed to have a clean install for the source side of the Anderson SB50 connector. A notch is needed to be cut into the mounting material to get the bracket front face mounted...

    $21.00
    Add to Cart
  • Late 80 Series Toyota Switch Blank (TSB-1)

    Late 80 Series Toyota Switch Blank

    The OEM Toyota snap-in switch blanks are used to fill in the blanks when a switch isn't needed on the Useless Astray Switchplate- Toyota Switches. The blanks are black and simply pop into place. Part no: 55539-32010-C0 Options:• Carling Switch...

    $4.75
    Add to Cart
  • Microphone Button- Basic 1/4-20" (MBB-1)

    Microphone Button- Basic 1/4-20

    Although this microphone button was initially designed for use with the Useless Cubby Insert, it was also designed to be universal. All you need is a flat surface and a 1/4"-20 threaded hole and you have a mic button. This mic button is made from Delrin...

    $15.00
    Add to Cart
  • 1N4001 diode

    80 Series Auto-Up Mod Diode

    If your 80 Series Land Cruiser or LX450 has power windows then this mod is for you. Currently your driver's side window has a feature known as Auto-Down. This means that not only can you control the window's movement up and down but with one deliberate...

    $1.50
    Add to Cart