With this kit you can convert the 2-sprayer nozzle from your 80 Series Land Cruiser and convert it to the 3-sprayer nozzle. This gives the windshield more covered and replaces the often times clogged sprayers. Includes the two clips needed to remove to get access to the nozzles. The original spec'd part number for these are 85281-12260 but Toyota has NLA'd those so the replacement is now 85381-42070. These are ADJUSTABLE nozzles. This means all you need to do is install them and then use a needle or thumbtack to stick into the nozzle in order to redirect the spray to where you want them on the windshield.
• (2) Hood insulator clip (90467-09014)
• (2) Washer nozzle (85381-42070)
• (1) OEM washer hose (90099-33080)
Made in JAPAN
5 Reviews Hide Reviews Show Reviews
This upgrade is a must! The new nozzles work GREAT!
Bought these with my windshield washer heater upgrade. So much coverage and the mud is gone so much faster. And the frost is gone quicker too!
I wish there were some directions provided. To be honest, I haven't looked into installing this, and I'm sure it's easy, but have a quick run-through of what needs to happen would have been appreciated.
This was a great cheap upgrade from the old two nozzle OEM setup on my 1993 FZJ80. If you ever need to replace a component of the washer setup you might as well knock this mod out as well.
It was easy to remove the original original fasteners to get to the nozzles in order to remove and replace them. Took less ten minutes to complete the job. I was hoping for a spray, but these stream like the original two-hole nozzles. I do have to aim the three holes on each nozzle for they are currently aiming below the lowest point of the wiper arm range. Not currently effective, but that should take another 10 minutes to address.