Axle Components

  • Toyota Truck ABS Sensor Delete Plugs- Full Kit (ABS-1KIT) Toyota Truck ABS Sensor Delete Plugs- Full Kit (ABS-1KIT)

    80 Series ABS Sensor Delete Plugs- Full Kit

    NOTE: Deleting your ABS is NOT recommended but many still do it for a myriad of reasons. Off-Road brake control and axle conversions are two reasons. Use at your own risk. This is been on my “to do” list for a pretty long time. For those...

    $70.00
    Add to Cart
  • 80 Series Driveshaft Hardware Kit-Rear 11mm (DCS-3) 80 Series Driveshaft Hardware Kit-Rear 11mm (DCS-3)

    80 Series Driveshaft Hardware Kit-Rear 11mm

    This is the complete driveshaft hardware for most Land Cruisers on the road. This kit replaces the washer/nut on the transfer case side and the bolt/washer/nut on the differential side. The 11mm rear driveshaft hardware fits:• All FJ60 Series Land...

    $20.00
    Add to Cart
  • 80 Series Inner Axle Seal Offset Driver (ASD-1) 80 Series Inner Axle Seal Offset Driver (ASD-1)

    80 Series Inner Axle Seal Offset Driver

    There is one thing that comes as a right of passage in owning an 80 Series and that is the rebuilding of our front knuckles. Generally speaking its not terribly technical, just messy and takes along time. Especially the first time. But there can be...

    $32.00
    Add to Cart
  • 80 Series OEM Knuckle Arm Nut Set (KAN-1)

    80 Series OEM Knuckle Arm Nut Set

    Note: Price INCLUDES four nuts, washers and cone washers These are one of those things that SHOULD be part of your spares kit. If these go missing on your truck you could lose your steering...quickly. Includes:• (4) 94115-71200 Toyota OEM...

    $25.50
    Add to Cart
  • 80 Series OEM Lower Knuckle Stud Kit (KAN-2)

    80 Series OEM Lower Knuckle Stud Kit

    When you are looking to replace your factory knuckle studs due to a rebuild or because your knuckle arm is missing a bolt, these are the OEM replacements. The only difference is the E12 Torx which makes them easier to install. This is for one side and...

    $17.50
    Add to Cart
  • Modified 54mm Hub Nut Tool (HUB-1) Modified 54mm Hub Nut Tool (HUB-1)

    Modified 54mm Hub Nut Tool

    This socket starts out as your standard OTC 6612 1/2" drive 54mm Hub Socket that is Made in USA. This hub socket is needed anytime you are going to work on your Toyota's 4WD front hub. The reason for modifying this hub socket is so that it can be dual...

    $52.00
    Add to Cart