Created with Sketch. Created with Sketch.

On-Board-Air (OBA)

  • 1.5in, 0-200PSI Gauge, 1-8NPT Back Mount (OBA-200-1-8B) 1.5in, 0-200PSI Gauge, 1-8NPT Back Mount (OBA-200-1-8B)

    1.5in, 0-200PSI Gauge, 1-8NPT Back Mount

    Liquid filled pressure gauges are perfect for On-Board-Air (OBA) applications. The glycerin liquid inside enhances reliability and readability of the gauges by dampening the effect of vibration and pulsation which is very common on an OBA setup where a...

    $13.00
    Add to Cart
  • York 1/2in. AN pass-thru fitting (YRK-9) York 1/2in. AN pass-thru fitting (YRK-9)

    1FZ 1/2in. AN pass-thru fitting

    This is the second side of the fittings needed for the suction side hose on the York OBA install on the 1FZ motors found on the 80 Series Land Cruisers. There is a small hole that needs to be drilled into the air filter canister that allows this fitting...

    $31.00
    Add to Cart
  • 2.5 Gallon Air Tank Kit (OBA-25) What comes in the OBA-25 kit along with the air tank.

    2.5 Gallon Air Tank Kit

    One major component of a dedicated On-Board-Air system is the air tank. The air tank stores compressed air at the ready for air up tires or operating air tools. Air tools are nearly impossible to use without the use of a compressed air tank. The Wits'...

    $150.00
    Add to Cart
  • 2in, 0-160PSI Gauge, 1-4NPT Bottom Mount (OBA-160-1-4L) 2in, 0-160PSI Gauge, 1-4NPT Bottom Mount (OBA-160-1-4L)

    2in, 0-160PSI Gauge, 1-4NPT Bottom Mount

    Liquid filled pressure gauges are perfect for On-Board-Air (OBA) applications. The glycerin liquid inside enhances reliability and readability of the gauges by dampening the effect of vibration and pulsation which is very common on an OBA setup where a...

    $14.00
    Add to Cart
  • 80 Series 3-Groove Water Pump Pulley (WPP-1) 80 Series 3-Groove Water Pump Pulley (WPP-1)

    80 Series 3-Groove Water Pump Pulley

    Note: This may fit other applications other than the 1FZ but its intended application is the 1FZ. Any usage outside of the 1FZ for the York OBA is outside of the scope of the design and there is no warranty. On the 1FZ powered 80 Series Land Cruisers...

    $165.00
    Add to Cart
  • 80 Series Air Manifold and Mount KIT (AMM-1) 80 Series Air Manifold and Mount KIT (AMM-1)

    80 Series Air Manifold and Mount KIT

    The 80 Series Air Manifold KIT is another piece of the On Board Air puzzle. This Air Manifold KIT comes with a custom bracket that mounts to the passenger side inner fender beside the air canister. The bracket holds the manifold which is the attachment...

    $295.00
    Add to Cart
  • 80 Series Rear Air Tank Shelf (RATS-1) 80 Series Rear Air Tank Shelf (RATS-1) sample setup with 2.5 gallon air tank and regulator

    80 Series Rear Air Tank Shelf

    One of the hardest parts of an On-Board-Air (OBA) system is where to mount the air tank. You can sometimes find a location to mount a compressor but rarely a compressor and tank. The Rear Air Tank Shelf (RATS-1) gives you a secure location, under your 80...

    $200.00
    Add to Cart
  • 80 Series York discharge hose KIT (YRK-14)

    80 Series York discharge hose KIT

    Getting the York 210 mounted to your 1FZ Land Cruiser is only half the battle. Next you have to plumb it. The suction line is the first component but then you need the discharge hose kit next to get you from the York to the coalescing filter. This hose...

    $70.00
    Add to Cart