Created with Sketch. Created with Sketch.

70 Series HD Land Cruiser (up to 1/90)

  • 11mm Driveshaft Bolt- Spare (DCS-11) 11mm Driveshaft Bolt- Spare (DCS-11)

    11mm Driveshaft Bolt- Spare

    Individual OEM 11mm driveshaft bolt. Although you can get an entire 10mm driveshaft hardware or 11mm driveshaft hardware kit, sometimes it helps to have a few 11mm bolts as a spare.

    $1.50
    Add to Cart
  • 80 Series Driveshaft Hardware Kit-Rear 11mm (DCS-3) 80 Series Driveshaft Hardware Kit-Rear 11mm (DCS-3)

    80 Series Driveshaft Hardware Kit-Rear 11mm

    This is the complete driveshaft hardware for most Land Cruisers on the road. This kit replaces the washer/nut on the transfer case side and the bolt/washer/nut on the differential side. The 11mm rear driveshaft hardware fits:• All FJ60 Series Land...

    $20.00
    Add to Cart
  • Fuel Injector Connector Housing (FIC-1) Fuel Injector Connector Housing (FIC-1)

    Fuel Injector Connector Housing

    Original Toyota Sumitomo 2 Way TS Plug Housing for Denso Injectors. Connector ONLY. Terminals not included. These connectors are ALWAYS brittle and tend to break after 20+ years on our trucks. They seem to want to break at the most inopportune time. You...

    $8.00
    Add to Cart
  • Land Cruiser Shock Bolt and Washer (SBW-1)

    Land Cruiser Shock Bolt and Washer

    These are the shock bolts that are used in several models of Land Cruiser. These tend to not only rust out but they also tend to get damaged during off-roading. • 60/62 series: rear upper and lower, front lowers (6 needed)• 70 series Heavy...

    $2.85
    Add to Cart
  • Toyota Magnetic Differential Plug Kit (DPK-1) Aluminum vs Steel crush washers

    OEM Magnetic Differential Plug Kit

    These OEM Magnetic Differential Plugs fit all Toyota 2WD and 4WD trucks and SUVs. These are the hex plugs that replace the easily damaged diff fill and drain plugs. The originals can be easily damaged from off-roading or from a tool rounding out the hex...

    $11.00
    Add to Cart
  • OEM Magnetic Transfer or Trans Case Drain Plug Kit (DPK-2) Aluminum vs Steel crush washers

    OEM Magnetic Transfer or Trans Case Drain Plug Kit

    These OEM Magnetic Transfer Case Plugs fit nearly all Toyota 2WD and 4WD trucks and SUVs (does not fit the FJ Cruiser auto). These are the hex plugs that replace the easily damaged drain plugs. The originals can be easily damaged from a tool rounding out...

    $11.00
    Add to Cart
  • OEM Panel Trim Retainer-Maroon (PTR-1)- sold individually

    OEM Panel Trim Retainer- Maroon

    You know when you are removing plastic trim panels from your Toyota or Lexus vehicle and those stupid little retainer clips ALWAYS break? Do you know why they break? It turns out you touched them. A decade or two of time and heat cycles will do that to...

    $2.00
    Add to Cart
  • OEM Steel Wheel Chock (SWC-1) OEM Steel Wheel Chock (SWC-1)

    OEM Steel Wheel Chock

    It should go without saying that ALL vehicles should have a pair of wheel chocks for safety. Every time you are repairing your truck or replacing a tire or anything that requires you to be under it, a wheel chock is a must. If you have a pair of wheel...

    $25.00
    Add to Cart
  • OEM Washable Cyclonic Air Filter (AIR-1) OEM Washable Cyclonic Air Filter (AIR-1)

    OEM Washable Cyclonic Air Filter

    OEM washable air filter that works for the 80 Series 3FE and 1FZ but also the heavy duty 7x series and diesel motors with the cyclonic air filter housing. Yes, the filter is washable and reusable. Made in JAPAN

    $26.00
    Add to Cart
  • Toyota FIPG 103 Adhesive (TOY-103) 00295-00103 Toyota FIPG 103 Adhesive (TOY-103) 00295-00103

    Toyota FIPG 103 Adhesive

    TOYOTA OEM specified adhesive for the oil pan and camshaft housing. Suggested Applications: Valve covers, oil pans, intake manifold end seals, timing covers, water pumps, thermostat housings. OEM part # 00295-00103 • Assemble parts within 15...

    $13.50
    Add to Cart
  • Toyota FIPG 1281 Adhesive (TOY-1281)

    Toyota FIPG 1281 Adhesive

    TOYOTA OEM specified RED adhesive for the transmission pan. Formed-in-Place Transmission Gasket is a high-performance RTV silicone used as a formed-in-place transmission gasket to seal various flange and large clearance surfaces in order to prevent oil,...

    $21.00
    Add to Cart